Ebode IP Vision 58 Manual de usuario descargar pdf (Pagina 58)

Manual version 1 – March 2012 58 IP Vision 58

Sender: Make sure the sender mailbox server provider support SMTP, and the mailbox should not enable SSL

or TSL encryption too.

Receiver: Here you can set four receivers. For receiver, there is no SMTP limitation.

SMTP Server: The sender’s SMTP Server.

SMTP Port: The sender’s SMTP Port, usually is 25, some SMTP server have its own port such as 587.

Need Authentication: If there is SMTP user & password, please select authentication.

SMTP User: Input correct SMTP User here. Some SMTP User is the sender’s full email address, such as

[email protected], some are without suffix, only the username, such as test.

SMTP Password: Input correct SMTP password here.

NOTE: Please click Submit firstly before choosing Test.

You will see the test result after click Test.

Figure 9.1

If it shows the following errors when you click Test. Please check whether the information you filled in is

incorrect and try again.

1) Cannot connect to the server.

2) Network Error. Please try later.

3) Server Error.

4) Incorrect user or password.

5) The sender is denied by the server. Maybe the server needs to authenticate the user, please check and try

again.

6) The receiver is denied by the server. Maybe because of the anti-spam privacy of the server.

7) The message is denied by the server. Maybe because of the anti-spam privacy of the server.

8) The server does not support the authentication mode used by the device.

Report Internet IP by Mail: If select it, you will receive emails which contain the camera’s internet IP. When

camera power on or Internet IP changed, it will send the internet IP by mail. (For example: IPCAM's URL is

http://121.213.109.69:1008

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 76 77

Sin comentarios

Ebode IP Vision 58 Manual de usuario Pagina 58