Ebode EM Guía de usuario descargar pdf (Pagina 7)

Transmitter - Wall-Mounted Remote Control Ref : EM

July 2009 page 7 EM

Mounting the EM switch to the wall

Operating the EM module

Check the address.

Simultaneously press the On and Off button shortly to check the

address.

Short press on the ON button, receivers with the same address will power on or

open (when used with shutter).

Short press on the OFF button, receivers with the same address will power off or

close (when used with shutter).

When changing the battery, the address will be retained.

e.g.: for B3 the red led will blink 2 times for the house code and the green led will

blink 3 times for the unit code. Wait until the yellow led blinks 3 times to indicate

the module has left the program mode.

1. Use a screwdriver to remove the mounting plate

from the switch cover. Be careful not to damage the

electronic circuit.

2. Attach the mounting plate to the wall using e.g.

double sided tape or 2 screws (2 mm) etc.

3. Reattach the cover to the mounting plate. Make

sure the ebode logo is on the right bottom.

C. Conguring the Unit Code

Press and release the ON key the appropriate number of times for

the Unit Code you want to set. Once for 1, twice for 2 etc.

The factory setting will be “1 = 1 Green Blink”

After setting the UNIT Code, the yellow LED blink 3 times, which

means the Unit Code is set and the module has leave the program

mode.

Stop

After setting the House Code, the Yellow LED will blink 3 times,

which means the House Code is set and the module has left the

program mode.

To now set the Unit Code, start from step A but skip step B and

go directly to step C.

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Sin comentarios

Ebode EM Guía de usuario Pagina 7